Installation Steps Of Aluminum Radiator

1. First, please unpack the aluminum radiator first, and install the air release valve and the union first.

2. The position of the hole for installing the special hook can be drawn on the wall according to the provided installation drawing or related requirements.

3. When installing aluminum radiators, consider the damage caused by the thermal expansion and contraction of the heating pipe to the radiator.

4. Put the 12 expansion tube in and level it.

5. Use a percussion drill to drill a hole of 12, the depth of which is after the expansion tube is put in, and the outer edge of the hole should be flush with the wall.

6. Install the bottom hook, and tighten the screws after reaching the requirements.

7. Place the aluminum radiator on the hook that has been installed at the bottom, install the upper hook to adjust the position of the hook, and then tighten the expansion screw after it is clamped. When placing the radiator, place the air release valve on the top.

8. After installing and assembling the pipe joints, install the pipes and connect them to the water inlet and outlet according to the drawings, and fasten them everywhere. The rear side is 3.5cm from the wall and 5cm from the kick line.

9. Please input hot water, open the bleed valve, and bleed until the water comes out. When the aluminum radiator is running, the working pressure listed in the manual must not exceed 0.12Mpa.

10. The oxygen content in the heat medium shall not exceed 0.05g per square meter. The medium water used for the radiator should meet PH9≤9, and PH≤12 when there are internal anti-corrosion measures.